Mitsubishi Electric DX-TL308E Manuale di Installazione Pagina 125

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 124
125
Troubleshooting
ENGLISH
If the problem with the recorder persist even after you check it according to the following chart, disconnect the power cord
and contact your dealer.
Installation
-
17,111 - 114
17
20
17,111 - 114
16
21, 120
24
40
-
-
17,111 - 114
38
17,111 - 114
19
19
38
99
62 - 65
38
52
-
17
24, 25
The recorder does not turn
on.
Power is on, but the recorder
does not work.
No images are displayed on
the monitor.
Images displayed on the
monitor are obscure.
Recording does not start.
Recording does not stop.
Repeat recording does not
start.
Timer recording does not
start.
Alarm recording does not
start.
Recording
Is the power cord properly plugged in?
Check that the LOCK indicator is not illuminating.
Check that the TIMER indicator is not illuminating.
Check that the MAIN switch on the rear panel is not OFF.
Check that the LOCK indicator is not illuminating.
Check that the POWER indicator is not blinking.
The recorder does not work while the POWER indicator is
blinking.
The protection functions may be working. Reset the recorder
by pressing the RESET button on the rear panel using a
pointed object such as a ballpoint pen and then turn on the
power again.
Are the monitor and cameras connected correctly?
Is the recorder receiving input signals from the selected
cameras?
Check this by displaying a 9-split screen (DX-TL308E)/4-split
screen (DX-TL304E).
Are the cords and cables connected correctly?
Is the camera focus adjusted correctly?
Check that the LOCK indicator is not illuminating.
Is repeat recording enabled?
Check that the LOCK indicator is not illuminating.
During normal recording, alarm recording, or emergency
recording, press and hold down the REC/STOP button for 2
seconds or longer.
When alarm recording by motion detection is being performed
repeatedly, set [Alarm input] to [Off] and then stop recording.
Check that timer recording is not in progress.
To cancel timer recording, press and hold down the TIMER
button for 2 seconds or longer.
Is repeat recording enabled?
Are the date and time set accurately?
Are the recording start and end times and the FPS rate set
correctly?
Is repeat recording enabled?
Check that FPS for alarm recording is not set to [---].
Is there recording capacity remaining?
Check that the recorder is not in the timer recording standby
mode.
(Check that the TIMER indicator is not illuminating.)
Are the external sensors and other devices connected
correctly?
Symptom Where to check Page
Vedere la pagina 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 163 164

Commenti su questo manuale

Nessun commento