Mitsubishi Electric PKA-A.GAL Manuale di Installazione

Air-ConditionersPKA-A·GAPKA-A·GALEnglishINSTALLATION MANUALFor safe and correct use, read this manual and the outdoor unit installation manual thoroug

10

137.2.3. Using SW4 in outdoor unitRefer to the outdoor unit installation manual.7.3. Self-check7.3.1. Wired remote controller (Fig. 7-3)1 Turn on the

14• If the unit cannot be operated properly after the above test run has been performed, refer to the following table to remove the cause.SymptomCause

15Maintenance mode operation procedures(1) Press the TEST button for three seconds toactivate the maintenance mode.(2) Press the TEMP. buttons to se

Please be sure to put the contact address/telephone number onthis manual before handing it to the customer.This product is designed and intended for u

2s Before installing the unit, make sure you read all the “Safety precau-tions”.s Please report to your supply authority or obtain their consent befor

32.1. Outline dimensions (Indoor unit) (Fig. 2-1)Select a proper position allowing the following clearances for installation and mainte-nance.(inch)Mo

43. Installing the indoor unit3.2.3. Installing the wall mounting fixtures Since the indoor unit weighs near 30 kg, 66 lbs selection of the mountinglo

54. Installing the refrigerant piping4.1. Precautions4.1.1. For devices that use R410A refrigerant• Use ester oil, ether oil, alkylbenzene oil (small

6Fig. 5-15. Drainage piping workABC5.1. Drainage piping work (Fig. 5-1)• Use a PVC pipe (I.D. ø20mm, 13/16 inch) for drain piping and provide 1/100 or

Indoor unit modelMinimum circuit ampacityMaximum rating of overcurrent protective deviceIndoor unit-Outdoor unit*1Indoor unit earthRemote controller-I

106. Electrical work6.2. Remote controller6.2.1. For wired remote controller1) Installing procedures(1) Select an installing position for the remote c

11PAR-21MAAON/OFFFILTERCHECKOPERATIONCLEARTESTTEMP.MENUBACK DAYMONITOR/SETCLOCKON/OFFABDCGEF41213 41 2A Pair No. of wireless remote controller Indoor